The math you need
Scientific notation, exponents, the half-life formula worked by hand, logarithms as 'how many halvings', a little probability, and how to read a log-scale graph — everything the site's tools assume, with nothing harder than algebra.
Nuclear numbers are awkward: atoms are counted in the trillions of trillions, half-lives run from nanoseconds to billions of years, and the interesting question is usually “how much is left after this long?” Five ideas handle all of it. None of them needs more than the algebra in a first high-school course.
1. Scientific notation
Writing 602,000,000,000,000,000,000,000 is a good way to lose a zero. Scientific notation moves the decimal point and keeps count of how far it moved:
602,000,000,000,000,000,000,000 = 6.02 × 10²³
The exponent (the 23) is the number of places the decimal point moved to the left. A negative exponent means it moved to the right — a small number:
0.000 000 000 000 000 000 16 = 1.6 × 10⁻¹⁹
Two rules do most of the work:
- To multiply, multiply the front numbers and add the exponents: (2 × 10⁵) × (3 × 10⁴) = 6 × 10⁹.
- To divide, divide the front numbers and subtract the exponents: (6 × 10⁹) ÷ (2 × 10⁵) = 3 × 10⁴.
Calculators write 6.02 × 10²³ as 6.02E23. The site’s tools accept that form too.
Two numbers worth knowing. One mole of anything is 6.02 × 10²³ of it (Avogadro’s number). One mole of carbon-12 weighs 12 grams; one mole of uranium-238 weighs 238 grams — the mass number in grams, near enough. So a gram of U-238 contains (1 ÷ 238) × 6.02 × 10²³ ≈ 2.5 × 10²¹ atoms. That is how the calculator turns “1 gram” into a number of atoms.
2. Units and prefixes
Nuclear quantities come with prefixes that are just powers of ten:
| Prefix | Symbol | Means | Example |
|---|---|---|---|
| kilo | k | 10³ | 1 kBq = 1,000 decays per second |
| mega | M | 10⁶ | 1 MBq = a million per second |
| giga | G | 10⁹ | 1 GBq — a typical medical-imaging dose |
| tera | T | 10¹² | 1 TBq |
| milli | m | 10⁻³ | 1 mCi = 0.001 curie |
| micro | μ | 10⁻⁶ | 1 μg = a millionth of a gram |
| nano | n | 10⁻⁹ | 1 ns = a billionth of a second |
For time, the site uses seconds, minutes, hours, days, and years. One year is about 3.156 × 10⁷ seconds — useful when a half-life is given in one unit and the time you care about in another. Always get both into the same unit before you divide one by the other.
3. Exponents and “how many halvings”
Unit 3 showed that after each half-life, half of what was there remains. After two half-lives, half of a half: a quarter. After three, an eighth. The pattern is a power of one-half:
after k half-lives, the fraction left is (½)ᵏ
| k | (½)ᵏ | as a decimal |
|---|---|---|
| 1 | ½ | 0.5 |
| 2 | ¼ | 0.25 |
| 3 | ⅛ | 0.125 |
| 5 | 1/32 | 0.031 |
| 10 | 1/1,024 | ≈ 0.001 |
| 20 | 1/1,048,576 | ≈ 0.000 001 |
Ten half-lives is the rule of thumb for “about a thousandth left”; twenty for “about a millionth.”
The exponent k does not have to be a whole number. (½)^0.5 is the square root of one-half, about
0.71 — what is left after half a half-life. Any calculator with a xʸ or ^ key will do it:
0.5 ^ 0.5.
4. The half-life formula
Put the last two sections together and you have the one formula on this page:
N = N₀ × (½)^(t / T½)
- N₀ is how much you started with (atoms, grams, or becquerels — it works for all three).
- t is the time that has passed.
- T½ is the half-life, in the same unit as t.
- t / T½ is the number of half-lives that have passed, whole or not.
- N is how much is left.
Worked example 1 — whole number of half-lives. A hospital receives 8 GBq of technetium-99m (half-life 6.0 hours) at 6 a.m. How much is left at 6 p.m.?
t = 12 h, T½ = 6 h, so t / T½ = 2. N = 8 × (½)² = 8 × ¼ = 2 GBq.
Worked example 2 — not a whole number. Same shipment; how much is left at noon the next day (30 hours later)?
t / T½ = 30 ÷ 6 = 5. N = 8 × (½)⁵ = 8 ÷ 32 = 0.25 GBq. Now try 3 p.m. the same day, 9 hours: t / T½ = 1.5. (½)^1.5 = 0.354, so N = 8 × 0.354 = 2.8 GBq. That is between the 4 GBq you would have at one half-life and the 2 GBq at two — as it should be.
Worked example 3 — mixed units. How much of a sample of carbon-14 (half-life 5,700 years) is left after 20,000 years? t / T½ = 20,000 ÷ 5,700 = 3.51. (½)^3.51 = 0.088, so about 9 percent remains. Check it against Unit 3’s table: after 3 half-lives, 12.5 percent; after 4, 6.25 percent; 3.51 half-lives should land between, and it does.
The fraction left, N / N₀, is the same whether you count atoms or measure activity in becquerels, because activity is just the number of atoms times a constant. That is why the decay calculator lets you type either.
5. Logarithms: running the formula backwards
The formula answers “how much is left after time t?” Carbon dating asks the reverse: “how much time has passed, if this much is left?” That means solving for the exponent, and the tool for pulling a number out of an exponent is the logarithm.
You do not need the theory. You need one fact: a logarithm answers the question “what exponent gets me here?” log₂(8) = 3 because 2³ = 8. log₁₀(1,000) = 3 because 10³ = 1,000. And for half-lives, the number of halvings k that takes you from N₀ down to N is
k = log₂(N₀ / N)
Most calculators have log (base 10) and ln (base e) but not log₂. Either one works if you
divide by the same kind of log of 2:
k = log(N₀ / N) ÷ log(2)
Worked example 4 — carbon dating. A piece of wood has 23 percent of the carbon-14 that living wood has. N₀ / N = 1 ÷ 0.23 = 4.35. log(4.35) ÷ log(2) = 0.638 ÷ 0.301 = 2.12 half-lives. Age = 2.12 × 5,700 = about 12,000 years. Sanity check: 25 percent would be exactly two half-lives, 11,400 years; 23 percent is a little less, so a little older. Good.
Worked example 5 — how long until it is “gone”? A radiation safety rule of thumb says a short-lived source can be treated as ordinary waste after ten half-lives. For iodine-131 (half-life 8.0 days) that is 80 days; the fraction left is (½)¹⁰ ≈ 0.001. If instead you asked “how long until only one part in a million is left?”: k = log(1,000,000) ÷ log(2) = 6 ÷ 0.301 = 19.9 half-lives, about 160 days.
6. A little probability
Unit 3 said you cannot predict when one nucleus will decay, only the odds. Here is the whole of what “odds” means here.
Imagine 1,000 dice, each rolled once a second. A die “decays” when it shows a six. Each second, about one-sixth of the remaining dice decay and are taken away. You cannot say which die will go next, but you can say with confidence that after one second about 833 remain, after two about 694, and so on. The “half-life” of a die is the time for half to be gone — about 3.8 rolls.
A nucleus is a die with a very lopsided chance per second. For carbon-14 the chance that any given nucleus decays in a given second is about 4 × 10⁻¹² — four in a trillion. That sounds like nothing, but a gram of carbon has 5 × 10²² atoms, of which about 6 × 10¹⁰ are carbon-14, and four in a trillion of those is about 0.2 decays per second. Multiply tiny odds by an enormous number of atoms and you get a steady, measurable rate. That is the whole trick.
Two consequences. First, the curve is smooth only because the numbers are huge; with a few atoms, decay is jerky and random, and the site’s calculator will happily show you a network with three atoms of polonium-214 in it — treat the fractional atom counts it prints as averages. Second, a nucleus has no memory. A carbon-14 atom that has survived 20,000 years is no more “due” than one made yesterday. Its odds for the next second are exactly the same.
7. Reading a log-scale graph
The decay calculator’s plots have a check-box for log axes. On an ordinary axis, equal distances mean equal amounts: 0, 100, 200, 300. On a logarithmic axis, equal distances mean equal multiples: 1, 10, 100, 1,000. Each step is ten times the last.
Why bother? Two reasons.
- Range. A uranium-238 decay chain contains U-238 with a half-life of billions of years and polonium-214 with a half-life of 0.16 milliseconds. On one ordinary time axis you would see either the U-238 or the Po-214 and never both. A log time axis shows nanoseconds and eons on the same picture.
- Shape. Exponential decay — the curve from section 4 — is a straight line on a log vertical axis. Each half-life drops the line by the same distance. So on a log plot, a steeper straight line means a shorter half-life, and a curve that bends means something is being added (a daughter growing in from its parent) as well as decaying.
Reading tip: on a log axis the tick marks between the big labels are not evenly spaced. Between 10 and 100 the marks are at 20, 30, 40 … 90, and they bunch up toward the top. Halfway across the decade is not 50 — it is about 32 (the square root of 10, times 10).
Try it
- Open the decay calculator with Tc-99m, 8 GBq, 30 hours. Read the activity off the table at 12 h and 30 h and check them against worked examples 1 and 2.
- Set up carbon-14, any amount, 20,000 years. Switch the vertical axis to log. Is the line straight? Read off the fraction at 20,000 years and compare it with worked example 3.
- Run the U-238 series preset with log axes on. Find the flat stretch where U-238 has not changed and the daughters have all grown in to match it — that is called secular equilibrium, and the math of why it happens is the next thing to learn after this page.
Where this comes from
The mathematics is standard; the half-life relation and its logarithmic inverse are in every introductory chemistry and physics text. Avogadro’s number is exactly 6.02214076 × 10²³ by the 2019 definition of the mole. Half-lives used in the examples (technetium-99m 6.0 h; carbon-14 about 5,700 y; iodine-131 8.0 d; polonium-214 0.16 ms) are from the evaluated nuclear data behind the site’s tools. The carbon-14 decay probability per second is the natural log of 2 divided by the half-life in seconds, ln 2 / (5,700 × 3.156 × 10⁷ s) ≈ 3.9 × 10⁻¹² per second. The carbon-14 abundance in living carbon, about 1.2 parts in 10¹², is the standard figure in radiocarbon references. The dice model of decay is a common classroom demonstration.